60 Hz
LONG CASE AXIAL FAN 300ºC/2h ATEX
MANUFACTURING FEATURES:
• Long case axial fan with reinforced body.
• Modular motor-impeller assembly. Cast aluminium impeller with variable pitch angle. Polyester powder finishing coat.
• Housing with motor access door.
• Standard asynchronous squirrel-cage motor with IP-55 protection and Class H insulation certified 300ºC/2h and ATEX (II3G). Manufactured with standard voltages: 400V(Y) 60Hz in three phase motors up to 3kW and 400V 60Hz for higher powers and 2 speed motors.
APPLICATIONS:
Designed for inline installation, they are suitable for:
• Smoke emergency exhaust with motor inside the hazardous area and high pressures needed.
• Maximum working temperature: 60ºC.
UNDER REQUEST:
• Supply impeller (air direction from impeller to motor)
• 100% reversible impeller.
Official homologation by the European laboratory APPLUS according to EN 12101-3:2015
Certification Nr: 0370-CPR-2400
| E | O | ØA | ØB | ØDint | ØJ |
|---|---|---|---|---|---|
| 560 | 12x30º | 646 | 620 | 559 | 12 |
Set that allows to install short or long case fans on the roof protecting them from inclement weather. Kit suitable for fire (metal cap).
MANUFACTURING FEATURES
Set consisting of:
•Cowl made of galvanized sheet.
• Support framework for roof adaptation in laminated steel sheet protected against corrosion by powder coating polyester resin.
• Anti-bird protection grid protected against corrosion.
APPLICATIONS
Designed for roof installation, they are indicated for:
• Renovation of air in all types of buildings and industries.
• Smoke extraction.
• Contribution of clean air.
• Maximum temperature subject to installed fan.
UNDER REQUEST
• Framework support in AISI 304,316.
• Cold galvanized steel.
• Hot galvanized steel.
MANUFACTURING FEATURES
Set consisting of:
• Protection grids on both sides (RP), in compliance with the directive ROHS 2002/95/EC (Restriction of hazardous substances in electrical and electronic equipment).
• Tilt support (PS) made of steel and protected against corrosion with polyester resin powder.
• Possibility of orienting the air jet in any position.
• Applicable to HM, HMA, HMF and HMFX.
MANUFACTURING FEATURES
• Safety start-stop switches according to IEC 60947-1 and IEC 60947-3.
• IP65 and always equipped an auxiliary contact.
• Useful for switching off the current before handling the fan.
*Máx. thermal current air (A)
Switch for ATEX environments. Suitable for zones 1-2 (gas) and 21-22 (dust), index protection IP65. Manufactured in aluminum alloy and RAL 7000 gray finishing coat. External screws in stainless steel. Control on the front. Tensions up to 690V. According to directive 2014/34 / UE (ATEX).
+34 972 720 150